2/1/2024 0 Comments Prepo fuel canisterYou may also find it difficult to fill up the fuel tank at the gas station without making a mess. The most common symptom of a bad charcoal canister is a check engine light on your dashboard. But it's more toxic and carcinogenic than either butane or propane if you can about that sort of thing.Charcoal Canister Replacement Cost Symptoms Of A Bad Charcoal Vapor Canister Hotter than propane, even hotter than map-pro. That stuff burns hot and transfers heat fast. They're usually 75% isobutane (aka methylpropane) with propane and a little butane mixed in. What you really want is those flat isobutane camp fuels. You can get turbo torches meant for those butane camp gas canisters for less money than an adapter costs though. It doesn't transfer heat the same way, and it is much harder to control and less precise than propane. Because of this it can't heat a single spot very well. Butane in a ts8000 makes a very large cone of a flame. The flame characteristics are different too. The pressure is far too low for most propane torches. You will get a very small flame that will make the torch very hot and possibly blow the canister. A regular solid brass pencil flame propane torch will not work with butane. Leaks between the adapters are very possible.Īnd it will ONLY work with a the most expensive propane torches, the ones with built in regulators that are map-pro compatible with flames with names like "swirl", "turbine" or "turbo torch" like the bernzomatic ts8000 or the turbo torch STK-9 because the high venturi effect and the nozzle on these models will pressurize the butane to high enough levels on its on. You'll have to grease the gaskets on the adapters with synthetic silicone grease to maintain a seal and the threads of the adapters with a similiar synthetic inert PTFE grease because these adapters are made in china out of whatever scrap metal they have lying around and sparks are very possible just screwing the thing on and off. The adapters are going to cost you $10/piece and you'll need at least 2. With the right adapters and with the right brazing torch. If it does work, you may go through a lot more butane for the job than the amount of propane that would be required. It may be good enough, but it isn't likely to be as effective with a torch designed for propane as using propane. The only way to tell if it will be effective is to try it. You want to use it for a demanding application. The canister connection may also be different depending on size, but is you're asking the question, I'm guessing that issue doesn't apply. All the torches I've seen designed for butane are small, but designed to get the optimum flame from the butane. So a torch designed for propane may not give the best butane flame. Nozzles designed for butane are different, and a different air/fuel mix is required. That wouldn't make any difference for a camping stove, but brazing steel is more demanding. They have similar BTUs, but the rationale is that the butane flame is more diluted because it takes more combustion air. If you're working in freezing temperatures, you may even have trouble feeding the torch.Īlso, I've read that butane doesn't transfer its heat as effectively (see this for example). So if you're burning it at a fast rate, the pressure will be different. Butane has a much higher boiling point than propane (31 F vs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |